The test methods ASTM D, ASTM D, and IP 75 describe the laboratory determination of water and sediment in fuel or crude oils in the range from 0. This test method covers the determination for water and sediment in fuel oils ( ASTM D) or crude oils (ASTM D) by the centrifuge method. The TC16 is . Astm d Standard Test Method for Water and Sediment in Fuel Oils by Centrifuge Method (Laboratory Procedure) – Free download as PDF File .pdf) or read.
|Published (Last):||19 July 2014|
|PDF File Size:||12.84 Mb|
|ePub File Size:||15.10 Mb|
|Price:||Free* [*Free Regsitration Required]|
After centrifugation, the volume of the higher density water and sediment layer at the bottom of the tube is read. Vapour extracted is diluted with air, and is safely discharged into a d196 area.
The TC16 is used for precise temperature control offers high reliability for use under rough circumstances.
The liquid bath has place for nine cone-shaped centrifuge tubes. The bath has place for nine centrifuge cones. Copyright Stanhope—Seta Limited The TC16 is according to the requirements of the ASTM D test method where a water bath is prescribed to preheat the cone-shaped centrifuge tubes.
The vacuum inside the chamber is monitored by a vacuum switch, and the system is interlocked to ensure safe d796 of the centrifuge. It is further equipped with a mechanical resettable safety thermostat and a drain to empty the bath.
The Hazard Reduction System only requires connection to a compressed air supply and the centrifuge. Operation – You operate the lid using the control panel. Historical Version s – view previous versions of standard Translated Version s: Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not r1796 as part of the standard.
Eight-inch Centrifuge Cone for ASTM D & D
The cone-shaped centrifuge tubes are immersed in the vertical position to the mL mark in a liquid bath of sufficient depth. Setafuge Hazard Reduction System The optional Setafuge Hazard Reduction System prevents the uncontrolled release of hazardous vapours from the centrifuge. The system extracts vapour from near the top rim of the chamber, maintaining the pressure in the chamber at slightly below atmospheric.
Go to Wish List.
With some types of fuel oils such as residual fuel oils or distillate fuel oils containing residual components, it is difficult to obtain water or sediment contents with this test method.
The centrifuge is fitted with a safety interlock to prevent the rotor running when the lid v1796 unlocked.
ASTM D Accessories – ASTM Accessories – Accessories
Link to Active This link will always route to the current Active version of the standard. The Oil Test Centrifuge is a microprocessor controlled, programmable, heating d17966 that meets the above standards. Click here for 6-place Centrifuge. Why is it important to determine the water and sediment is fuels?
ASTM D1796 – 11(2016)
The water and sediment content of fuel oil or crude oil is significant because it can cause corrosion of equipment and problems in processing. You use the centrifuge to determine water and sediment in oils. You can also save test parameters as a program so they can be quickly recalled.
A determination of water d7196 sediment content is required to measure accurately net volumes of actual fuel or crude oil in sales, taxation, exchanges, and custody transfers. Safety features – A motor driven lid latch with a safety interlock to prevent centrifuge f1796 while the lid is unlocked.
Please contact our sales team sales tamson. A determination of water and sediment content is x1796 to measure accurately net volumes of actual fuel oil in sales, taxation, exchanges, and custody transfers.